News

Find out what's happening around Barbados.

This article was published more than one month ago. The information may no longer be relevant or up to date.

This article was published more than one month ago. The information may no longer be relevant or up to date.

Highway 4 roadworks starting on January 13th, 2024

January 14, 2024

January 12, 2024

Residents and visitors in Salters, St. George are advised that C.O. Williams Construction Ltd will be conducting roadworks on Highway 4 between Salters and Constant Roundabout starting January 13th, 2024.

Milling will take place on January 13th, 2024 and January 14th, 2024 between the hours of 7:30 AM and 5:30 PM.

Paving will take place from January 15th, 2024 through January 19th, 2024 between the hours of 7 PM and 6 AM.

During the roadworks, access to this section of Highway 4 will be restricted to local traffic and emergency vehicles only.

Motorists approaching from Errol Barrow Highway will need to turn left at Salters (see map). After passing Chefette, bear right to stay on the current road (see map). Turn right at the junction with the Glebe Public Market (see map). For persons travelling to Constant or Dash Valley, turn right just before St. George Primary School (see map). For persons travelling to Brighton, Ellerton or Lower Greys, drive past St. George Primary School and bear right to stay on the current road (see map).

Motorists approaching from Dash Valley or Constant will need to take the north exit at Constant Roundabout towards St. George Primary School (see map). Continue straight ahead for about 1km. At the end of the road, turn left towards the Glebe Public Market (see map). At the junction with the Glebe Public Market, turn left (see map). At the Sol Gas Station, turn left onto Salters (see map). For persons travelling to Errol Barrow Highway, continue for about 1.6 km to the junction with Highway 4 and turn right (see map).

Go Back

Get the latest news sent to your inbox. It's free. Unsubscribe anytime.

You are now subscribed. Thank you!
Something went wrong. Please try again.